For anyone who might want this. Here are the Instructions for the Victor Fibre Needle Cutter. This is from May of 1913. That's about it from this end on the subject of Fibre needles and needle cutters. I do believe probably everyone has had their fill of this subject for now.
Instructions for Victor Fibre Needle Cutter
- solophoneman
- Victor II
- Posts: 315
- Joined: Wed Jan 07, 2009 8:05 pm
- MordEth
- Victor IV
- Posts: 1148
- Joined: Wed Jan 07, 2009 1:01 pm
- Personal Text: Contact me for TMF tech support.
- Location: Boston, MA
- Contact:
Re: Instructions for Victor Fibre Needle Cutter
Instructions
How to Operate the
Victor Fibre Needle Cutter
To repoint Victor Fibre Needles:
- Place the needle in the needle slot, as shown in Fig. 1, with the point towards the front of cutter, then gently push the needle towards cutting blade until the point touches the needle guide on lever.
- Hold the needle firmly in place and press lever down with steady stroke. This will repoint the needle. (Should the blade fail to perfectly repoint the needle, turn the adjusting screw a little to the right. (See Fig. 2).
To resharpen Blade:
- Remove the screw at top of top blade (See Fig. 1). Then lift blade from lever.
- Resharpen blade with oil stone.
To replace Blade:
- Place top blade in position on lever with beveled side of blade next to lever, as shown in Fig. 3, with slot over adjusting screw.
- Insert screw at top of top blade. Make sure that this is screwed up tightly.
- Now adjust tension of top blade by means of adjusting screw until pressure of top blade on lower blade is sufficient to insure cutting a perfect point on needle.
New blades may be purchased from any Victor dealer at 25c each.
Victor Talking Machine Co.
Camden, N. J.
Proudly supporting phonograph discussion boards, hosting phonograph sites and creating phonograph videos since 2007.
Need web hosting or web (or other graphic) design? Support MordEth by using BaseZen Consulting for all of your IT consulting needs.
Want more phonograph discussion? Be sure to visit The Online Edison Phonograph Discussion Board.
Need web hosting or web (or other graphic) design? Support MordEth by using BaseZen Consulting for all of your IT consulting needs.
Want more phonograph discussion? Be sure to visit The Online Edison Phonograph Discussion Board.