The Talking Machine Forum — For All Antique Phonographs & Recordings

It is currently Tue Dec 10, 2019 5:08 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Victor 4-3
PostPosted: Tue Jun 23, 2015 4:39 pm 
Offline
Victor IV
Joined: Fri Jun 08, 2012 1:14 pm
Posts: 1227
I just ordered a replacement back bracket for this machine (my last project)from Ron S. I made an attempt to remove the old bracket which is on the verge of becoming powder to see how the tone arm comes off. The very bottom of the tone arm back bracket which attaches to the cabinet is made of steel. I separated the two pieces and notice the pot metal section extends into the steel bottom plate and contains the notch to limit tone arm travel. This whole pot metal ring remained in the steel section which contains the ball bearings for the tone arm. Curious if the repro back brackets contain the pot metal section that mates with the steel section. Does anyone have the instructions on how the tone arm separates from the old back bracket :D Thanks

Bill K


Attachments:
003.JPG
003.JPG [ 82.51 KiB | Viewed 436 times ]
Top
 Profile  
 
 Post subject: Re: Victor 4-3
PostPosted: Wed Jun 24, 2015 4:31 pm 
Offline
Victor IV
Joined: Fri Jun 08, 2012 1:14 pm
Posts: 1227
Case closed I won. :D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Bing [Bot], Inigo, Majestic-12 [Bot], poodling around and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Americanized by Maël Soucaze.