Before and After, Your Proudest Salvage Machines Projects

Jerry B. · Post by **Jerry B.** » Wed Oct 18, 2017 6:31 am

Many have seen this but the change was dramatic. Jerry B.

StL Bill · Post by **StL Bill** » Wed Oct 18, 2017 8:53 am

This has been one of my more challenging projects. Not completely done yet, but well on my way. I still am working on the upper and lower film reel holders, but I see light at the end of the tunnel.
Bill

Post by **alang** » Wed Oct 18, 2017 8:55 am

Wow! That is an unbelievable transformation. Congratulations!

Andreas

Post by **tomb** » Wed Oct 18, 2017 11:31 am

Very good Bill... I will bring the popcorn for a showing. Tom B

rvwenger · Post by **rvwenger** » Fri Oct 20, 2017 5:50 am

I'm a rank amateur as compared to some of you. I have only tackled heavy duty finish cleaning and some minor wood repairs. Stripping and veneering I have yet to do. This is a VV-X that had some wood damage and a finish that was very very dirty but no veneer lifting or damage. What could I hurt by learning on this one. I am proud of repairing stripped screws from a botched repair of the lid hinge. My next goal on this is to do the resto on the Victor plate at some point. A winter project.

Django · Post by **Django** » Fri Oct 20, 2017 5:54 am

This has been one of my more challenging projects. Not completely done yet, but well on my way. I still am working on the upper and lower film reel holders, but I see light at the end of the tunnel.
Bill

It is hard to believe that some of these restorations began with so little to work with.

Before and After, Your Proudest Salvage Machines Projects

Re: Before and After, Your Proudest Salvage Machines Project

Re: Before and After, Your Proudest Salvage Machines Project

Re: Before and After, Your Proudest Salvage Machines Project

Re: Before and After, Your Proudest Salvage Machines Project

Re: Before and After, Your Proudest Salvage Machines Project

Re: Before and After, Your Proudest Salvage Machines Project