Starr Reproducer?
-
- Victor II
- Posts: 417
- Joined: Sun Jan 01, 2017 4:27 pm
- Location: Tennessee
Starr Reproducer?
Picked up a little table top Sonora and they had an extra reproducer with it. Any ideas? I am sure its just an off brand but thought it was interesting.
- PeterF
- Victor IV
- Posts: 1914
- Joined: Sun Jul 08, 2012 1:06 pm
Re: Starr Reproducer?
http://forum.talkingmachine.info/viewto ... =2&t=33525
Google around a little and you'll find more info, too.
Google around a little and you'll find more info, too.
-
- Victor II
- Posts: 417
- Joined: Sun Jan 01, 2017 4:27 pm
- Location: Tennessee
Re: Starr Reproducer?
Thank you!!PeterF wrote:http://forum.talkingmachine.info/viewto ... =2&t=33525
Google around a little and you'll find more info, too.
-
- Victor I
- Posts: 140
- Joined: Thu Apr 13, 2017 11:00 am
- Location: Nova Scotia
Re: Starr Reproducer?
I find the graphics on the Reproducer to be quite handsome and so I did a bit googling and found this article online from the Canadian Antique Phonograph Society about the company reps in Canada.
http://www.capsnews.org/apn2008-3.htm
The picture of the tabletop can't be clicked on to enlarge, but if you make the page big enough I think I can make out the reproducer looks like yours.
PS. With 4 machines in various stages of repair I think its time I finally became a member
http://www.capsnews.org/apn2008-3.htm
The picture of the tabletop can't be clicked on to enlarge, but if you make the page big enough I think I can make out the reproducer looks like yours.
PS. With 4 machines in various stages of repair I think its time I finally became a member
-
- Victor II
- Posts: 417
- Joined: Sun Jan 01, 2017 4:27 pm
- Location: Tennessee
Re: Starr Reproducer?
burke wrote:I find the graphics on the Reproducer to be quite handsome and so I did a bit googling and found this article online from the Canadian Antique Phonograph Society about the company reps in Canada.
http://www.capsnews.org/apn2008-3.htm
The picture of the tabletop can't be clicked on to enlarge, but if you make the page big enough I think I can make out the reproducer looks like yours.
PS. With 4 machines in various stages of repair I think its time I finally became a member
Good find! Thank you.
I agree its a great looking reproducer. The graphics are great!