Hi folks! I am repairing an Orthophonic reproducer for a friend, and I've encountered something that I haven't seen before. The needle chuck pivots on the needle bar. Is this normal? It seems to me that it would cause wear/damage to records played with it since the needle can sit at an odd angle to the record groove. The reproducer is from an early Granada model (straight horn, no speaker screen type from 1925).
I have rebuilt Orthophonics before, but I have not seen this type of construction on the needle chuck/needle bar. I will add a couple of photos in a few minutes so that you can see what I am talking about.
Any information about this? Just an earlier design that I haven't seen?
Thank you!
Ed
Orthophonic reproducer rebuild
- Edisonh19
- Victor I
- Posts: 129
- Joined: Fri Mar 06, 2015 8:04 pm
- Location: Pittsburgh
-
- Victor V
- Posts: 2183
- Joined: Sat Jul 09, 2016 7:12 pm
Re: Orthophonic reproducer rebuild
I suspect that the needle chuck area worked itself loose from the needle bar at this joint --Edisonh19 wrote:... The needle chuck pivots on the needle bar. Is this normal? ...
FROM: http://i.ebayimg.com/00/s/MTE4MlgxNjAw/ ... 880000500F
After detaching the needle bar foot from the diaphragm, you'll have to knock out the pivot rod (shown next to the needle bar) to remove the needle bar, and then solder it.
OrthoFan
- Edisonh19
- Victor I
- Posts: 129
- Joined: Fri Mar 06, 2015 8:04 pm
- Location: Pittsburgh
Re: Orthophonic reproducer rebuild
Thanks so much for the response! I haven't seen one loose like this before. I learn something new all the time with these machines and parts. Thank you for the information!