So, I was taking apart the reproducer to my tabletop machine, and after removing the 3 screws that held the back on and lifting off the back, I ran into a problem. There doesn't seem to be a way to break it down any further. There are no screws or seams where it could come apart, it seems. Any suggestions on what to do next to continue the rebuild? I can't find any information about this reproducer online.
http://forum.talkingmachine.info/downlo ... w&id=97360
http://forum.talkingmachine.info/downlo ... w&id=97361
Help Rebuilding Sonora Reproducer
- Ho_Hum
- Victor O
- Posts: 91
- Joined: Thu Jul 05, 2018 3:50 pm
- Personal Text: College is hard :(
- Location: New York City
-
- Victor Monarch
- Posts: 4172
- Joined: Wed Jan 07, 2009 4:23 pm
- Personal Text: I have good days...this might not be one of them
- Location: Albany NY
Re: Help Rebuilding Sonora Reproducer
you may have to pry out that petrified rubber ring in the back and free the tube, but it doesn't come apart further. The diaphragm lifts out of the front once you remove the gasket- The gasket is the only thing holding it in place.
- Ho_Hum
- Victor O
- Posts: 91
- Joined: Thu Jul 05, 2018 3:50 pm
- Personal Text: College is hard :(
- Location: New York City