I picked up a Victor II with no horn today. Can anyone tell me the diameter of the elbow where it fits into the casting? I am not sure if this is a cobble job or not. By the way, this is not the later slip in elbow.
Thanks in advance.
Dave
Elbow diameter of Victor II info needed
-
- Victor IV
- Posts: 1229
- Joined: Wed Aug 01, 2012 8:43 pm
- Location: Port Huron, MI
- Phonolair
- Victor III
- Posts: 598
- Joined: Wed Jan 07, 2009 4:23 pm
- Location: Michigan
Re: Elbow diameter of Victor II info needed
Hi Dave
Small end of the elbow that fits into the back bracket is 1.5 " OD
Larry Crandell
Small end of the elbow that fits into the back bracket is 1.5 " OD
Larry Crandell
-
- Victor IV
- Posts: 1229
- Joined: Wed Aug 01, 2012 8:43 pm
- Location: Port Huron, MI
Re: Elbow diameter of Victor II info needed
Hi Larry,
Thanks for taking the time to help me with this. I sent you a PM.
Dave
Thanks for taking the time to help me with this. I sent you a PM.
Dave