Aluminum Diaphragm in Type AT Reproducer
-
- Victor V
- Posts: 2987
- Joined: Fri Jan 09, 2009 2:47 am
- Location: Jerome, Arizona
- Contact:
Aluminum Diaphragm in Type AT Reproducer
Bought a low-trunnion Type AT Graphophone yesterday and it has an aluminum diaphragm. Before I dismiss this as someone’s hack repair job, has anyone ever seen an aluminum diaphragm in a floating reproducer before? The diaphragm appears to be quite old. I haven’t disassembled the reproducer yet.
"All of us have a place in history. Mine is clouds." Richard Brautigan
- startgroove
- Victor III
- Posts: 887
- Joined: Sat Apr 20, 2013 3:01 pm
- Location: Coos Bay, Oregon
Re: Aluminum Diaphragm in Type AT Reproducer
Many years ago I had a floating reproducer (I can't remember which style) with an aluminum diaphragm. It had the same problem, where the needle bar did not "stick" well to the diaphragm. I tried Super Glue as a last resort, and it worked for a little while. I assumed it was a later replacement, and so, replaced it with mica and glued the needle bar on with varnish. It stayed together after that.
-
- Victor V
- Posts: 2987
- Joined: Fri Jan 09, 2009 2:47 am
- Location: Jerome, Arizona
- Contact:
Re: Aluminum Diaphragm in Type AT Reproducer
Thanks! Confirmation of another aluminum diaphragm!
"All of us have a place in history. Mine is clouds." Richard Brautigan