Need a photo of lid support on VV 4-7

[chrisg]

Trying to help a gentleman out. He contacted me needing the lid support hinge. I think i got a junk one twenty years ago and parted it. I have the support i think was on it. But he said his as two hole on the lid and two screw holes on the motor board. Any photo would be great.

[OrthoFan]

I saw this online --

Capture.JPG (39.63 KiB) Viewed 1168 times

FROM -- https://www.ebay.com/itm/VICTOR-Victrol ... 7675.l2557

Hope this helps.

OrthoFan

[chrisg]

Maybe they had several type. The supports i saved look like the photo below. But what you show sounds like what he described. Thanks

[mattrx]

I saw this online --

Capture.JPG

FROM -- https://www.ebay.com/itm/VICTOR-Victrol ... 7675.l2557

Hope this helps.

OrthoFan

I once had a 4-7 that had this same lid support. I no longer have it, unfortunately, or I'd post photos. It did not have the 2 spring loaded arms shown in another post. There could well have been variations, I suppose. There often were.

Matt

[AZ*]

My 4-7 is similar to the image that chrisg posted.

[chrisg]

Thank you to all. I guess I will see when he brings it in

[OrthoFan]

According to "The Victor Data Book" by Robert Baumbach, the spring balanced lid supports were introduced with the model VV 4-7 (type A) starting with serial number 38001.

OrthoFan

[vansteem78]

Mine is SN 11046 and has the support with two screws at each end. Nice machine. My first orthophonic. Neil

[electrolaman 64]

The 4-7 had spring loaded pots like a credenza. I junked a 4-7 earlier this year and have the lid supports if someone needs them. In fact I ahve all of the hardware form this model and the grille.

Carlton Smith
Indianapolis, IN