Question on victrola motor part spec. (size of pin)

Share your phonograph repair & restoration techniques here
Post Reply
User avatar
rizbone
Victor III
Posts: 544
Joined: Tue May 08, 2012 6:17 pm
Location: Maryland

Question on victrola motor part spec. (size of pin)

Post by rizbone »

Does anyone know the diameter of the pin that holds the large winding gear in place on the L-door machines (fits in the slot ground into the back of the gear and passes through the shaft holding the springs in)? I can't remember if it is ⅛, 3/32 or if it is a tapered pin.
Top
Post Reply

Return to “Tips, Tricks, & Tutorials”