I recently had cause to locate a difficult-to-find turntable for an itinerant Paillard GGR 255 spring motor. Not having success, I therefore determined to seek out a quality company capable of making a High Speed Steel taper reamer. I sent the firm a loose spindle and established that the taper is completely non-standard at 0.0908”/inch---crazy measurement and clearly the reasons for such a strange gradient were known only to Paillard themselves !
I now have such a reamer and the capability of converting any turntable tapered centre to this specification should anyone else have a similar requirement---please forward a PM.
The service and quality of the firm which made the reamer was second to none and I would recommend them unreservedly for any specialist work.
Will Prangle
Technical Sales Director
DRILL SERVICE (HORLEY) LTD.
23 Albert Road
Horley
Surrey
RH6 7HR
UK
Tel: +44 (0)1293 774911
Email: will.prangle@drill-service.co.uk
Paillard GGR 255 turntable taper.
- emgcr
- Victor IV
- Posts: 1088
- Joined: Mon Jul 02, 2012 9:57 am
- Location: Hampshire, England.
- Contact: