Page 1 of 1

Question on Triumph Motor

Posted: Thu Jan 11, 2018 8:42 am
by rizbone
One of the gears on my Triumph has come loose. It looks like it was originally press fit but is no longer tight (see letter A in picture). My question is, can this be soldered, or is that not going to be enough to hold it in place. Also, the end pin on the shaft (letter B) has sheared off. Wondering if anyone has a spare hanging around.

Re: Question on Triumph Motor

Posted: Thu Jan 11, 2018 9:58 am
by rgordon939
Did you check with Ron Sitko for the gears? His number in NY is ‭(518) 371-8549‬.

Rich Gordon