Page 1 of 1

Columbia belt wont stay on

Posted: Mon May 14, 2018 4:49 pm
by 12jslater
On my new Columbia BQ the belt keeps riding up onto the left flange on the madrel, however if i don't have the tensioner on the belt the issue goes away and the belt is straight.

Re: Columbia belt wont stay on

Posted: Mon May 14, 2018 7:41 pm
by Phonofreak
I have ran into this problem, also. Sometimes these belts have a slight curve to either the left or right. Separate and remove the belt. Run the belt length over a table top or work bench. Run back and forth. This will stretch the belt a bit, and check to make sure that the belt is perfectly straight. To re-attach the belt, bevel the edges about ¼" overlap. Then use contact cement to hold the joint. This should work. This method also works with Edison, and other belted machines.
Harvey Kravitz

Re: Columbia belt wont stay on

Posted: Mon May 14, 2018 10:11 pm
by phonogfp
I have found that sometimes, simply removing the belt and reversing it (not inside-out, but right-to-left) will solve the problem.

George P.