Cygnet horn bracket placement
Posted: Sun Aug 19, 2018 11:23 pm
For the last couple months I have been restoring and building an Edison standard Model F and recently purchased a very nice Cygnet horn for the machine. The case I am using was originally from a Model E standard and does not have the holes drilled in the back for the Signet horn bracket. Does anybody have any suggestions for determining the proper location where the bracket should be attached to the back of the case in order for the horn to fit properly? Are there any diagrams available for that or anything else that I should look out for when doing it? I will post later a little on how I restored this machine.
Thank you,
Stephen
Thank you,
Stephen