Hello all:
I need to remove the three spring barrels from this Garrard No. 7a motor to have the springs cleaned and re-greased. It appears that they're held in place by a single shaft with one set screw, like Victor motors. Before diving in, are there any issues I should know?
Gentle tapping hasn't moved it yet, and I don't want to damage anything. Springs are all wound down and relaxed.
Thanks for any help!
Bob Barnett
Help needed: Garrard No. 7a spring barrel removal advice
- barnettrp21122
- Victor IV
- Posts: 1601
- Joined: Thu Jan 08, 2009 4:19 pm
- Personal Text: "Did you ever stop to think that pleasure is a duty?" (Victor sales pamphlet)
Help needed: Garrard No. 7a spring barrel removal advice
"Comparison is the thief of joy" Theodore Roosevelt
His Master's Voice Automatic 1A Exponential Gramophone Demonstration:
https://www.youtube.com/watch?v=Qi70G1Rzqpo
His Master's Voice Automatic 1A Exponential Gramophone Demonstration:
https://www.youtube.com/watch?v=Qi70G1Rzqpo
- barnettrp21122
- Victor IV
- Posts: 1601
- Joined: Thu Jan 08, 2009 4:19 pm
- Personal Text: "Did you ever stop to think that pleasure is a duty?" (Victor sales pamphlet)
Re: Help needed: Garrard No. 7a spring barrel removal advice
Well, I've answered my own question; The spring barrel shaft tapped out just fine after putting a little Kroil on it and letting it sit a few minutes.
Bob
Bob
"Comparison is the thief of joy" Theodore Roosevelt
His Master's Voice Automatic 1A Exponential Gramophone Demonstration:
https://www.youtube.com/watch?v=Qi70G1Rzqpo
His Master's Voice Automatic 1A Exponential Gramophone Demonstration:
https://www.youtube.com/watch?v=Qi70G1Rzqpo