 |
Victor I |
Joined: Sun Jul 30, 2017 5:28 pm Posts: 146 Location: Deltona FL / Brampton ON
|
Here is a tip to ensure there is no belt slip on your cylinder machines. Some machines like the Edison Standard has a polished pulley that is not friendly to belt slip.
I cut a strip from a roll of fabric bandage or bandaid the width of the pulley groove. Stretch the strip while applying to the groove. This will reduce the original thickness of the bandage. Do not overlap the ends. Cut at the correct length butting the ends to ensure uniformity.
Attachments: |

pulley2.jpg [ 62.41 KiB | Viewed 616 times ]
|

pulley.jpg [ 37.94 KiB | Viewed 616 times ]
|
|
|