Does anyone know what the thread pitch is on the screws used for the governor springs on Victor Victrolas? I mean the ones that hold the spring to the opposite parts of the governor, not the one that holds the weight to the spring.
Thanks!
Dave D
What's the thread pitch on Victrola governor spring screws?
-
- Victor IV
- Posts: 1229
- Joined: Wed Aug 01, 2012 8:43 pm
- Location: Port Huron, MI
-
- Victor VI
- Posts: 3719
- Joined: Tue Mar 23, 2010 7:00 pm
- Location: Western, WA State
Re: What's the thread pitch on Victrola governor spring scre
It's been a while since I did this, but I think it is 1-72. I know Ron Sitko sells these.
Don't forget the little washers, too.
Harvey Kravitz
Don't forget the little washers, too.
Harvey Kravitz
-
- Victor IV
- Posts: 1229
- Joined: Wed Aug 01, 2012 8:43 pm
- Location: Port Huron, MI
Re: What's the thread pitch on Victrola governor spring scre
Thanks, Harvey!
Dave
Dave