The Talking Machine Forum — For All Antique Phonographs & Recordings

It is currently Thu Dec 05, 2019 2:26 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 5 posts ] 
Author Message
 Post subject: Question on spray finishes...
PostPosted: Wed Aug 14, 2019 2:10 pm 
Offline
Victor Monarch Special
Stop for a visit when in Oregon.
Joined: Tue Feb 10, 2009 12:25 pm
Posts: 6543
Location: Albany, Oregon
I recently acquired an oak machine that has been refinished. It looks like a nice job but the finish is too light. I asked the previous owner about the finish and it is a lacquer. Is there an overspray that is tinted or am I looking at a refinish? Thanks for any tips. Jerry Blais


Top
 Profile  
 
 Post subject: Re: Question on spray finishes...
PostPosted: Wed Aug 14, 2019 2:37 pm 
Offline
Victor V
Joined: Tue Jan 21, 2014 12:55 am
Posts: 2441
Location: Eugene/ Springfield Oregon USA
Jerry- Try mixing some stain into your Deft and spray some samples to see how it lays down. I have done this before and it seems to work quite well but I can't recall exactly if it was Deft I used, or if I tinted varnish as a base coat and then sprayed Deft over it.
"He who dies with the most shellac wins"- some nutty record geek


Top
 Profile  
 
 Post subject: Re: Question on spray finishes...
PostPosted: Sat Aug 17, 2019 12:52 am 
Offline
Victor Monarch Special
Stop for a visit when in Oregon.
Joined: Tue Feb 10, 2009 12:25 pm
Posts: 6543
Location: Albany, Oregon
Is there a product already in a spray can? Thanks, Jerry


Top
 Profile  
 
 Post subject: Re: Question on spray finishes...
PostPosted: Sat Aug 17, 2019 1:07 am 
Offline
Victor V
Joined: Tue Jan 21, 2014 12:55 am
Posts: 2441
Location: Eugene/ Springfield Oregon USA
Jerry B. wrote:
Is there a product already in a spray can? Thanks, Jerry


Not that I'm aware of... sorry.

EDIT- I did some digging and found this:
https://woodrepairproducts.com/product/ ... gKLBfD_BwE
"He who dies with the most shellac wins"- some nutty record geek


Top
 Profile  
 
 Post subject: Re: Question on spray finishes...
PostPosted: Sat Aug 17, 2019 9:51 am 
Offline
Victor Monarch Special
Stop for a visit when in Oregon.
Joined: Tue Feb 10, 2009 12:25 pm
Posts: 6543
Location: Albany, Oregon
Thanks George, I appreciate your efforts. Jerry


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Americanized by Maël Soucaze.