Victor III Spring Barrels
-
- Auxetophone
- Posts: 2587
- Joined: Wed Jan 14, 2009 5:01 am
Victor III Spring Barrels
Does anyone have any experience with Victor III springs? They are unlike any I have done before. I don't see any logical way to remove the rod and open the barrels.
-
- Auxetophone
- Posts: 2587
- Joined: Wed Jan 14, 2009 5:01 am
Re: Victor III Spring Barrels
Evidently you have to pry the gear up on the other end of the shaft first. It was really stuck on there!
- antique1973
- Victor IV
- Posts: 1281
- Joined: Mon Mar 22, 2010 3:30 am
- Personal Text: Victor Z, Victrola 4-3
Re: Victor III Spring Barrels
Brandon wrote:Evidently you have to pry the gear up on the other end of the shaft first. It was really stuck on there!
Yep, that's why I dislike this iteration of Victor motors. Just getting to the springs
is a chore. Sounds like you figured it out, the main thing is to pry the gear straight
off so you don't damage the pin that fits in the gear sideways. Another weird thing
on these motors, the springs are both going the same direction just in case you did not
notice.