I'm in need of the fiber gear that connects the governor shaft in a Thorens Excelda.
The gear in the 2nd picture is an old 2010 photo from the forum that clearly shows the same gear in pristine condition.
The 1st picture is a photo of the actual gear that came out of my Excelda. It's still mounted on it's brass carrier, as I'm not certain it will come off without falling apart.
I used the old photo because it shows a very clear shot of just the gear that I need, in new condition. In the background, you see the same gear mounted inside the Thorens motor on a steel carrier.
In the photo of my actual gear; it's difficult to see and understand that the gear is a separate part from the brass carrier. My carrier is fine. I only need the gear; which is pressed, or "interference fitted" onto the brass carrier. It's also difficult to understand in the 1st photo that the concave condition of the outer edge is all from wear; unless you've seen the flat edge of the teeth on the new one.
Anyone have one of these laying around?
Thank you,
Les Delinski
Wanted: Thorens Excelda fiber gear
-
- Victor Jr
- Posts: 26
- Joined: Sun Sep 02, 2012 3:02 pm
Wanted: Thorens Excelda fiber gear
- Attachments
-
- IMG_8773sm.jpg (57.31 KiB) Viewed 447 times
-
- gear1.jpg (87.53 KiB) Viewed 447 times