Hello,
I am repairing a broken foot on my Victrola XVI. The base of the foot should have a metal cap or retaining ring which presumably stabilizes the wood to prevent splitting, which is what happened to mine. My damaged foot is missing this cap. I have all 4 casters, though one is damaged as well. I am looking primarily for the metal cap for the base of the foot, though an entire caster assembly, plus the cap and inner sleeve for the shaft would work. I can always make something, but I'd rather go with something original. Please see photos of the missing cap and one that is still present.
Thanks!
Mike
FOUND: Victrola XVI full caster assembly
- MikeB
- Victor II
- Posts: 398
- Joined: Mon Aug 30, 2010 9:28 am
FOUND: Victrola XVI full caster assembly
Last edited by MikeB on Fri Nov 17, 2017 2:00 pm, edited 1 time in total.
-
- Victor I
- Posts: 159
- Joined: Wed Aug 08, 2012 3:34 pm
- Location: Norman, Oklahoma
Re: Wanted: Victrola XVI full caster assembly
I have this set; if they will work, I'll take $35.00 + shipping. PM me if you like. Roy
-
- Victor O
- Posts: 92
- Joined: Sat Jan 10, 2009 1:01 pm
- Location: SW Montana
Re: Wanted: Victrola XVI full caster assembly
Mike, I have a set of 4 casters with the brass collars. I bought these from a forum member and never bothered to install them. I paid $40 and would sell for the same. I will try to figure out how to attach a photo, pm me if interested
- MikeB
- Victor II
- Posts: 398
- Joined: Mon Aug 30, 2010 9:28 am
Re: Wanted: Victrola XVI full caster assembly
I think I found the collar that I was looking for. Thanks, everyone!