FOUND: Part for Ultona 3-way reproducer.
-
- Victor IV
- Posts: 1228
- Joined: Fri Jun 08, 2012 1:14 pm
FOUND: Part for Ultona 3-way reproducer.
I need the end part that goes on the end of the middle section of a Ultona 3-way reproducer arm. A fellow forum member was gracious enough to send me the part that shattered. I now need whatever goes on the end of the small elbow - it is threaded for a screw and I have no clue what the 4 small holes are for. The shattered arm I have has a large threaded cap on the end. Thanks. Bill K
- Attachments
-
- DSCN1264.JPG (125.07 KiB) Viewed 319 times
-
- DSCN1265.JPG (123.89 KiB) Viewed 319 times
-
- DSCN1264.JPG (125.07 KiB) Viewed 319 times
Last edited by dutchman on Mon Nov 27, 2017 4:22 pm, edited 1 time in total.
- Crank_it_up
- Victor III
- Posts: 586
- Joined: Thu May 01, 2014 8:34 pm
- Location: South Florida
Re: WANTED: Part for Ultona 3-way reproducer.
Not mine, but just saw this on eBay. Might be the same part you need. Joe
https://www.ebay.com/itm/Antique-Brunsw ... SwO7haGB83
https://www.ebay.com/itm/Antique-Brunsw ... SwO7haGB83
-
- Victor IV
- Posts: 1228
- Joined: Fri Jun 08, 2012 1:14 pm
Re: WANTED: Part for Ultona 3-way reproducer.
Thanks - just got an Email from George V. who has what I'm looking for. Appreciate the heads-up. Bill K