Page 1 of 1

WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Mon Dec 04, 2017 3:52 pm
by Django
I am looking for a base cabinet to fit beneath my Victrola VV-X. The machine is Mahogany and it is 18.5" wide by 22.5" deep. I don't care if it would need to be mounted sideways. Shipped or I can take possession at Wayne in April.

There was a nice cut down VV-XVII or VV-XVIII cabinet at the Wayne show in October. That would be perfect if anyone knows of it's whereabouts.

Thanks,
George

Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Mon Dec 04, 2017 4:45 pm
by Hailey
I believe I have one in the garage. I can check once I get home, and then let you know.

Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Mon Dec 04, 2017 5:47 pm
by phonojim
I have one that I would have sold but I bought a XII two weeks ago.

Jim

Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Mon Dec 04, 2017 6:52 pm
by Hailey
Here is the cabinet that I have. I am not sure, but I believe that this cabinet was made specifically for your machine. Possibly some of the Forum members may know. The measurements of the outside top molding is exactly that of your machine.
It is totally original and would clean up fabulously. If you want it you can have it for $100. I am in NW Missouri.

Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Wed Dec 06, 2017 2:21 pm
by Django
Hailey wrote:Here is the cabinet that I have. I am not sure, but I believe that this cabinet was made specifically for your machine. Possibly some of the Forum members may know. The measurements of the outside top molding is exactly that of your machine.
It is totally original and would clean up fabulously. If you want it you can have it for $100. I am in NW Missouri.
This would be perfect, but it is too far away. If someone is within 200 miles of Claremont New Hampshire, or if they wouldn't mind delivering it to the Wayne show in April, that would be great. Greyhound Shipping is also a good option.

It doesn't have to be the correct stand, it just needs to fit and be Mahogany.

Thanks,
George

Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Sat Mar 17, 2018 11:42 pm
by OldRestorer
I saw this one in an antique shop on Long Island. I have no idea if it would work for you.
They want $129.00
Kirk

Re: Found: BASE CABINET FOR TABLE TOP VV-X VICTROLA

Posted: Sun Mar 18, 2018 1:01 pm
by Django
Found, Thank you Kirk. It will actually go beneath my VV-XII.