I am looking for a base cabinet to fit beneath my Victrola VV-X. The machine is Mahogany and it is 18.5" wide by 22.5" deep. I don't care if it would need to be mounted sideways. Shipped or I can take possession at Wayne in April.
There was a nice cut down VV-XVII or VV-XVIII cabinet at the Wayne show in October. That would be perfect if anyone knows of it's whereabouts.
Thanks,
George
WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA
- Django
- Victor IV
- Posts: 1693
- Joined: Thu Apr 13, 2017 7:31 pm
- Location: New Hampshire’s West Coast
-
- Victor III
- Posts: 541
- Joined: Tue Jul 23, 2013 2:44 pm
- Location: Missouri
Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA
I believe I have one in the garage. I can check once I get home, and then let you know.
-
- Victor IV
- Posts: 1429
- Joined: Wed May 20, 2009 8:20 pm
- Location: Mid - Michigan
Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA
I have one that I would have sold but I bought a XII two weeks ago.
Jim
Jim
-
- Victor III
- Posts: 541
- Joined: Tue Jul 23, 2013 2:44 pm
- Location: Missouri
Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA
Here is the cabinet that I have. I am not sure, but I believe that this cabinet was made specifically for your machine. Possibly some of the Forum members may know. The measurements of the outside top molding is exactly that of your machine.
It is totally original and would clean up fabulously. If you want it you can have it for $100. I am in NW Missouri.
It is totally original and would clean up fabulously. If you want it you can have it for $100. I am in NW Missouri.
- Django
- Victor IV
- Posts: 1693
- Joined: Thu Apr 13, 2017 7:31 pm
- Location: New Hampshire’s West Coast
Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA
This would be perfect, but it is too far away. If someone is within 200 miles of Claremont New Hampshire, or if they wouldn't mind delivering it to the Wayne show in April, that would be great. Greyhound Shipping is also a good option.Hailey wrote:Here is the cabinet that I have. I am not sure, but I believe that this cabinet was made specifically for your machine. Possibly some of the Forum members may know. The measurements of the outside top molding is exactly that of your machine.
It is totally original and would clean up fabulously. If you want it you can have it for $100. I am in NW Missouri.
It doesn't have to be the correct stand, it just needs to fit and be Mahogany.
Thanks,
George
- OldRestorer
- Victor III
- Posts: 535
- Joined: Sun Mar 19, 2017 7:14 pm
- Location: Long Island NY
Re: WANTED: BASE CABINET FOR TABLE TOP VV-X VICTROLA
I saw this one in an antique shop on Long Island. I have no idea if it would work for you.
They want $129.00
Kirk
They want $129.00
Kirk
It's not what you say... It's what you do...
- Django
- Victor IV
- Posts: 1693
- Joined: Thu Apr 13, 2017 7:31 pm
- Location: New Hampshire’s West Coast
Re: Found: BASE CABINET FOR TABLE TOP VV-X VICTROLA
Found, Thank you Kirk. It will actually go beneath my VV-XII.