WANTED Need parts for a Edison Standard 2-4 min machine

Buy, sell, or trade your phonograph-related items here [except music]
Post Reply
MesaMike
Victor Jr
Posts: 48
Joined: Sat Jan 20, 2018 8:19 pm

WANTED Need parts for a Edison Standard 2-4 min machine

Post by MesaMike »

I am missing several parts from the bedplate of a 2-4 minute Edison standard machine . Standard D I think.
Anybody have a junker?

Jerry B.
Victor Monarch Special
Posts: 8503
Joined: Tue Feb 10, 2009 11:25 am
Personal Text: Stop for a visit when in Oregon.
Location: Albany, Oregon

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Post by Jerry B. »

If possible it would make it much easier if you could post some photos of your machine. Thanks, Jerry Blais

Pete Stratford
Victor II
Posts: 206
Joined: Wed Sep 20, 2017 4:12 pm

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Post by Pete Stratford »

Hello,
I have this bed plate from a Standard model D. But what parts are you looking for?
Pete
Attachments
IMG_0081.JPG
IMG_0082.JPG

tomb
Victor IV
Posts: 1381
Joined: Sat Oct 24, 2015 10:46 pm
Location: riverside calif

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Post by tomb »

If you want to get the plate running you will need almost everything. You can buy a few parts at a time and spread the cost. I can not tell if the bearing has been changed but I think it is original. That needs to be changed then you will need a mandrel, mandrel pulley, , carriage and carriage rod and much more. It really depends what you want to do with this top plate. All the parts can get expensive. Tom B

MesaMike
Victor Jr
Posts: 48
Joined: Sat Jan 20, 2018 8:19 pm

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Post by MesaMike »

The bedplate in your photo has some of the parts I am looking for for sure.

I am missing:
the gear with the knob that pulls in and out of position.
The gear cover
The belt pulley that goes on the mandrel shaft
The feed screw and its 2 associated bearings (mine are present but look damaged)
other stuff I am unaware of?

I have attached a picture.
Attachments
IMG_1353.JPG

Jerry B.
Victor Monarch Special
Posts: 8503
Joined: Tue Feb 10, 2009 11:25 am
Personal Text: Stop for a visit when in Oregon.
Location: Albany, Oregon

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Post by Jerry B. »

That's a D or later Standard. It looks like Pete has most of the parts you need. Jerry Blais

Pete Stratford
Victor II
Posts: 206
Joined: Wed Sep 20, 2017 4:12 pm

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Post by Pete Stratford »

Hello,
I also have the mandrel pulley that came with that model D parts bed plate. Why don't you send me a P.M. or email me direct at
pstratford55@gmail.com and we can work out a deal.

Pete
Attachments
IMG_0089.JPG

Post Reply