Page 1 of 1

WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Sun Jan 21, 2018 8:39 am
by MesaMike
I am missing several parts from the bedplate of a 2-4 minute Edison standard machine . Standard D I think.
Anybody have a junker?

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Sun Jan 21, 2018 10:02 am
by Jerry B.
If possible it would make it much easier if you could post some photos of your machine. Thanks, Jerry Blais

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Sun Jan 21, 2018 10:46 am
by Pete Stratford
Hello,
I have this bed plate from a Standard model D. But what parts are you looking for?
Pete

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Sun Jan 21, 2018 5:17 pm
by tomb
If you want to get the plate running you will need almost everything. You can buy a few parts at a time and spread the cost. I can not tell if the bearing has been changed but I think it is original. That needs to be changed then you will need a mandrel, mandrel pulley, , carriage and carriage rod and much more. It really depends what you want to do with this top plate. All the parts can get expensive. Tom B

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Mon Jan 22, 2018 8:20 pm
by MesaMike
The bedplate in your photo has some of the parts I am looking for for sure.

I am missing:
the gear with the knob that pulls in and out of position.
The gear cover
The belt pulley that goes on the mandrel shaft
The feed screw and its 2 associated bearings (mine are present but look damaged)
other stuff I am unaware of?

I have attached a picture.

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Mon Jan 22, 2018 10:55 pm
by Jerry B.
That's a D or later Standard. It looks like Pete has most of the parts you need. Jerry Blais

Re: WANTED Need parts for a Edison Standard 2-4 min machine

Posted: Tue Jan 23, 2018 7:26 am
by Pete Stratford
Hello,
I also have the mandrel pulley that came with that model D parts bed plate. Why don't you send me a P.M. or email me direct at
pstratford55@gmail.com and we can work out a deal.

Pete