I am missing several parts from the bedplate of a 2-4 minute Edison standard machine . Standard D I think.
Anybody have a junker?
WANTED Need parts for a Edison Standard 2-4 min machine
-
- Victor Jr
- Posts: 48
- Joined: Sat Jan 20, 2018 8:19 pm
-
- Victor Monarch Special
- Posts: 8516
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
Re: WANTED Need parts for a Edison Standard 2-4 min machine
If possible it would make it much easier if you could post some photos of your machine. Thanks, Jerry Blais
-
- Victor II
- Posts: 207
- Joined: Wed Sep 20, 2017 4:12 pm
Re: WANTED Need parts for a Edison Standard 2-4 min machine
Hello,
I have this bed plate from a Standard model D. But what parts are you looking for?
Pete
I have this bed plate from a Standard model D. But what parts are you looking for?
Pete
-
- Victor IV
- Posts: 1383
- Joined: Sat Oct 24, 2015 10:46 pm
- Location: riverside calif
Re: WANTED Need parts for a Edison Standard 2-4 min machine
If you want to get the plate running you will need almost everything. You can buy a few parts at a time and spread the cost. I can not tell if the bearing has been changed but I think it is original. That needs to be changed then you will need a mandrel, mandrel pulley, , carriage and carriage rod and much more. It really depends what you want to do with this top plate. All the parts can get expensive. Tom B
-
- Victor Jr
- Posts: 48
- Joined: Sat Jan 20, 2018 8:19 pm
Re: WANTED Need parts for a Edison Standard 2-4 min machine
The bedplate in your photo has some of the parts I am looking for for sure.
I am missing:
the gear with the knob that pulls in and out of position.
The gear cover
The belt pulley that goes on the mandrel shaft
The feed screw and its 2 associated bearings (mine are present but look damaged)
other stuff I am unaware of?
I have attached a picture.
I am missing:
the gear with the knob that pulls in and out of position.
The gear cover
The belt pulley that goes on the mandrel shaft
The feed screw and its 2 associated bearings (mine are present but look damaged)
other stuff I am unaware of?
I have attached a picture.
-
- Victor Monarch Special
- Posts: 8516
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
Re: WANTED Need parts for a Edison Standard 2-4 min machine
That's a D or later Standard. It looks like Pete has most of the parts you need. Jerry Blais
-
- Victor II
- Posts: 207
- Joined: Wed Sep 20, 2017 4:12 pm
Re: WANTED Need parts for a Edison Standard 2-4 min machine
Hello,
I also have the mandrel pulley that came with that model D parts bed plate. Why don't you send me a P.M. or email me direct at
pstratford55@gmail.com and we can work out a deal.
Pete
I also have the mandrel pulley that came with that model D parts bed plate. Why don't you send me a P.M. or email me direct at
pstratford55@gmail.com and we can work out a deal.
Pete