I need the short straight tube that runs from the elbow outward, and to which the reproducer mounts, for many styles of Pathé disc machines. It typically has a short threaded stud which slips into a short slot on the elbow, with a knurled nut to secure it. The other end sometimes has a rubber isolator segment.
I don't need the elbow or reproducer but if you need to sell the whole shebang, I might take them to get what I need.
Hoping one of you finds something that's been languishing in the parts bin, awaiting this very moment.
Example pix attached.
Thanks.
WANTED: Pathé Tonearm part
- PeterF
- Victor IV
- Posts: 1917
- Joined: Sun Jul 08, 2012 1:06 pm
- PeterF
- Victor IV
- Posts: 1917
- Joined: Sun Jul 08, 2012 1:06 pm
Re: WANTED: Pathé Tonearm part
Added example photos.
-
- Victor IV
- Posts: 1533
- Joined: Wed Jan 07, 2009 10:07 pm
- Location: Lille, France
Re: WANTED: Pathé Tonearm part
I could probably get you one here in France from one of a few sources if you are willing to pay a finder's fee.
Garret
Garret
- PeterF
- Victor IV
- Posts: 1917
- Joined: Sun Jul 08, 2012 1:06 pm
Re: WANTED: Pathé Tonearm part
Thanks for the offer - probably not necessary, though, because it's not going to be that uncommon of a part here in the US. You can sure bring me back some etched-label center-start discs though! How long are you over there?
-
- Victor IV
- Posts: 1533
- Joined: Wed Jan 07, 2009 10:07 pm
- Location: Lille, France
Re: WANTED: Pathé Tonearm part
Until at least May 2019.