WANTED: Unusual Horn Crane Part - Top Section Only
- Crank_it_up
- Victor III
- Posts: 586
- Joined: Thu May 01, 2014 8:34 pm
- Location: South Florida
WANTED: Unusual Horn Crane Part - Top Section Only
I'm unsure of the maker of this little clever crane device was but I have an extra bottom section only and need the top part. It should include the angled ball shaped coupler and mine is about 22" long, but I would consider any length. The bottom section clips into the lid latch on an Edison Standard, possibly Home. Thanks, Joe
-
- Victor II
- Posts: 231
- Joined: Fri Jun 14, 2013 7:28 pm
Re: WANTED: Unusual Horn Crane Part - Top Section Only
Joe:
Like you, I only have the bottom section so I appreciate the picture as it confirms what the top section looks like. If you find two top sections put me in line
Thanks...
Kent
Like you, I only have the bottom section so I appreciate the picture as it confirms what the top section looks like. If you find two top sections put me in line
Thanks...
Kent
- Crank_it_up
- Victor III
- Posts: 586
- Joined: Thu May 01, 2014 8:34 pm
- Location: South Florida
Re: WANTED: Unusual Horn Crane Part - Top Section Only
Still looking for this crane part. Thanks, Joe