Page 1 of 2

WANTED: Cylinder reamer

Posted: Fri Apr 13, 2018 4:35 pm
by OldRestorer
I am going to try repairing a bunch of my cylinders. I would like a reamer. Used is fine, crappy is fine. It just needs to ReAm!

Thanks!
Kirk

Re: Want to buy: Cylinder reamer and Mandrel

Posted: Fri Apr 13, 2018 7:24 pm
by Stephen_Madara
I have an unused old oak reamer that needs sandpaper strips attached and an amberola mandrel I could let you have the pair for 40.00 plus actual shipping if you are interested.

Re: Want to buy: Cylinder reamer and Mandrel

Posted: Sun Apr 15, 2018 6:30 pm
by OldRestorer
I am going to need a shaft on the mandrel. Are there threads in the end that I can use a rod in? I see some online with shafts.
Thanks
Kirk

Re: Want to buy: Cylinder reamer and Mandrel

Posted: Sun Apr 29, 2018 10:11 am
by Lucius1958
OldRestorer wrote:I am going to need a shaft on the mandrel. Are there threads in the end that I can use a rod in? I see some online with shafts.
Thanks
Kirk
If it's from a 30/50/75, at least, it would have been held on the shaft by a collar with a set screw.

Bill

Re: Want to buy: Cylinder reamer and Mandrel

Posted: Sun Apr 29, 2018 1:50 pm
by Herman
OldRestorer wrote:I am going to need a shaft on the mandrel. Are there threads in the end that I can use a rod in? I see some online with shafts.
Thanks
Kirk
Have you found what you needed? I have a mandrel from a 2min only Home. Perfect for what you want as it has a very beefy shaft. No reamer though.

Herman

Re: Want to buy: Cylinder reamer and Mandrel W shaft

Posted: Sun Apr 29, 2018 2:51 pm
by OldRestorer
Hello,
I was offered the above but I need a shaft on it.
It should look like this photo below.
I need a good shaft for stability when trying to reform these cylinders. If it even works..

Kirk

Re: Want to buy: Cylinder reamer and Mandrel W shaft

Posted: Sun Apr 29, 2018 4:03 pm
by Herman
The most rigid shaft you will find attached to a mandrel is from the 2min Home as I mentioned in my post. Here is a picture sample I borrowed from a previous post from Victroladoctor. Hope he does not mind. The one I have is in my attic and too hot and lazy right now to bring it down to take pictures. The feedscrew threads on my mandrel are no good so no use on a phonograph but will suit your needs.

$25.00 includes shipping if you are interested.

Re: Want to buy: Cylinder reamer and Mandrel W shaft

Posted: Mon Apr 30, 2018 6:50 am
by OldRestorer
Looks good!
I will take it and will message you.
Kirk

Re: Want to buy: Cylinder reamer and Mandrel W shaft

Posted: Mon May 14, 2018 9:12 am
by OldRestorer
Mandrel found!

Stephen_Madara,
Can you sell me just the reamer?
Thanks,
Kirk

Re: WANTED: Cylinder reamer

Posted: Wed Jun 06, 2018 9:31 am
by OldRestorer
I have not heard back so I am STILL looking for a reamer.

Thanks,
Kirk