Page 2 of 2
Re: WANTED: Cylinder reamer
Posted: Wed Jun 06, 2018 9:07 pm
by earbleeder
I think I got mine from somebody named Bountiful antiques on eBay the other one listed on eBay was the wrong taper. So be careful check on a junk record first. It was well worth the 40 something dollars on one strip of sandpaper that came with it I did over 500 records easily and you can replace the Sandpaper with some from Menards for a couple bucks
Re: WANTED: Cylinder reamer
Posted: Thu Jun 07, 2018 8:40 am
by fmblizz
probably a dumb question but why do you need a mandrel and shaft??
just ream it and test on a machine...
what am I missing??
blizz
Re: WANTED: Cylinder reamer
Posted: Thu Jun 07, 2018 4:57 pm
by Herman
fmblizz wrote:probably a dumb question but why do you need a mandrel and shaft??
just ream it and test on a machine...
what am I missing??
blizz
I believe he is using it as a form to repair plaster from damaged cylinders. Waiting to hear his progress.
Re: WANTED: Cylinder reamer
Posted: Fri Jun 08, 2018 9:05 am
by OldRestorer
Missing?
I need a reamer. I roll dough with it..
Thanks for the heads up on the eBay ones. I don't want to throw $45.00 for the reamer and $12.00 for the sanding strips into this little project.
I am reforming the actual cylinder composite plastic. Then I will refill the plaster and groove it.
Kirk
Re: WANTED: Cylinder reamer
Posted: Fri Jun 08, 2018 9:16 am
by Herman
OldRestorer wrote:Missing?
I need a reamer. I roll dough with it..
Thanks for the heads up on the eBay ones. I don't want to throw $45.00 for the reamer and $12.00 for the sanding strips into this little project.
I am reforming the actual cylinder composite plastic. Then I will refill the plaster and groove it.
Kirk
Kirk, Bear in mind that the celluloid collapses in the area that there is plaster loss. You will end up with flat spots unless you have a method of applying pressure to expand the plaster. That is based on partial plaster loss repairs. For full plaster replacement you will most likely end up with reduced diameter of the cylinder overall.
Just my 2 cents input.
Good luck
Herman
Re: WANTED: Cylinder reamer
Posted: Fri Jun 08, 2018 7:01 pm
by OldRestorer
Yessir,
It will be a learning experience..
If I ever get a Reamer,
Re: WANTED: Cylinder reamer
Posted: Thu Jul 12, 2018 9:05 am
by Stephen_Heatherly
Re: WANTED: Cylinder reamer
Posted: Tue Oct 30, 2018 12:26 pm
by OldRestorer
Bump
Serial bumping here!