Page 1 of 1

WANTED: Parts for Victor "O" / "I" motor

Posted: Sun Jun 10, 2018 8:39 pm
by outune
I've had this Victor motor on my shelves for a couple decades I think. I need the small intermediate gear between the winding shaft gear and the gear that drives the barrel. (See pics). It looks like it would be about ¾" or so in diameter give or take a bit.

Also need the screw/cap that adjusts the spindle tension-- see pics.

According to the Harold Braker motor article, this is the CM motor used in the "O" and some Victor "I" machines.

I'd very much appreciate the help-
Thanks-
Brad Abell