I'm looking for an Excellent 10" Victor Pressed Steel Turntable to fit a Victor IV.
Must have excellent nickel.
(I'm not sure if a VV-IV turntable would work or not?)
Thanks in advance, Bob S.
WANTED: 10" Victor Pressed Steel Turntable for Victor IV
- Zwebie
- Victor IV
- Posts: 1381
- Joined: Thu Feb 23, 2012 2:55 pm
- Personal Text: We are only the caretakers for future generations.
- Location: FLORIDA
-
- Victor IV
- Posts: 1269
- Joined: Sun Oct 25, 2009 12:53 pm
- Location: Michiana
Re: WANTED: 10" Victor Pressed Steel Turntable for Victor IV
It depends upon which motor your machine uses. The earliest pressed turntables were used post-1909 on machines with double cut gears and bullet brakes. The same turntables were used on slightly later machines with quad-cut gears and pantograph brakes. There were at least yhlthree later "Victrola" motors used in the few late Victor IV machines. Heck, the last of them were fitted with the Burton motor and the little speed indicator window, just like a big VV-XI.
- Zwebie
- Victor IV
- Posts: 1381
- Joined: Thu Feb 23, 2012 2:55 pm
- Personal Text: We are only the caretakers for future generations.
- Location: FLORIDA
Re: WANTED: 10" Victor Pressed Steel Turntable for Victor IV
Here is a picture of the Motor and Top Board.
I hope this helps.
Bob S.
I hope this helps.
Bob S.
-
- Victor IV
- Posts: 1269
- Joined: Sun Oct 25, 2009 12:53 pm
- Location: Michiana
Re: WANTED: 10" Victor Pressed Steel Turntable for Victor IV
So.
You need the earliest of the
pressed steel turntables, the one
With the smooth center
And small boss.
You need the earliest of the
pressed steel turntables, the one
With the smooth center
And small boss.
- Zwebie
- Victor IV
- Posts: 1381
- Joined: Thu Feb 23, 2012 2:55 pm
- Personal Text: We are only the caretakers for future generations.
- Location: FLORIDA
Re: WANTED: 10" Victor Pressed Steel Turntable for Victor IV
Yes, that's what I need!
Thanks, Bob S.
Thanks, Bob S.