Just looking for a VV-VI crank if anyone has a spare.
thanks
Martin
FOUND: VV VI crank
- Mormon S
- Victor III
- Posts: 737
- Joined: Mon May 07, 2018 6:27 pm
- Personal Text: Martin "phono_fluff" on instagram
FOUND: VV VI crank
Last edited by Mormon S on Thu Mar 07, 2019 12:32 am, edited 3 times in total.
-
- Victor Monarch Special
- Posts: 8511
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
Re: Wanted: VV IV crank
We need more information. The Victrola IV was made for a long time and went through several variations.
- Mormon S
- Victor III
- Posts: 737
- Joined: Mon May 07, 2018 6:27 pm
- Personal Text: Martin "phono_fluff" on instagram
Re: Wanted: VV IV crank
Sorry, I made a dumb mistake, I mean VV-VI. Here is a picture if this helps.Jerry B. wrote:We need more information. The Victrola IV was made for a long time and went through several variations.
Thanks
Martin
-
- Victor VI
- Posts: 3718
- Joined: Tue Mar 23, 2010 7:00 pm
- Location: Western, WA State
Re: Wanted: VV VI crank
The crank you have looks pretty good. Ron Sitko sells replacement knobs.
Harvey Kravitz
Harvey Kravitz
- Mormon S
- Victor III
- Posts: 737
- Joined: Mon May 07, 2018 6:27 pm
- Personal Text: Martin "phono_fluff" on instagram
Re: Wanted: VV VI crank
Well, the tread at the end to hold the knob in place has broken off, and the screw has the end of the thread in it.Phonofreak wrote:The crank you have looks pretty good. Ron Sitko sells replacement knobs.
Harvey Kravitz
Martin
-
- Victor Monarch Special
- Posts: 8511
- Joined: Tue Feb 10, 2009 11:25 am
- Personal Text: Stop for a visit when in Oregon.
- Location: Albany, Oregon
Re: Wanted: VV VI crank
Not sure it applies here but the screw holding the wooden knob has a reverse thread. Jerry B.
- studebakerphonos
- Victor II
- Posts: 283
- Joined: Fri Feb 13, 2015 3:22 pm
- Personal Text: Skilled Craftsman produce radio cabinets at RCA Victor in Camden, N.J.
- Location: Eastern PA
Re: Wanted: VV VI crank
Excellent Point !Jerry B. wrote:Not sure it applies here but the screw holding the wooden knob has a reverse thread. Jerry B.
- Mormon S
- Victor III
- Posts: 737
- Joined: Mon May 07, 2018 6:27 pm
- Personal Text: Martin "phono_fluff" on instagram
Re: Wanted: VV VI crank
Still looking
- Mormon S
- Victor III
- Posts: 737
- Joined: Mon May 07, 2018 6:27 pm
- Personal Text: Martin "phono_fluff" on instagram
Re: Wanted: VV VI crank
nobody has the right crank?
- Mormon S
- Victor III
- Posts: 737
- Joined: Mon May 07, 2018 6:27 pm
- Personal Text: Martin "phono_fluff" on instagram
Re: Wanted: VV VI crank
still looking...