I am looking for a lower door knob to match the one pictured; it is 1 inch long.
Thanks
WANTED: Victrola door knob
-
- Victor Jr
- Posts: 6
- Joined: Sun Feb 17, 2019 8:18 am
- Location: Charlotte, NC
-
- Victor III
- Posts: 816
- Joined: Thu Sep 25, 2014 4:25 pm
- Location: North Central Iowa
Re: WANTED: Victrola door knob
Is it for a Victrola XVI?
- Skihawx
- Victor III
- Posts: 973
- Joined: Fri Aug 20, 2010 7:48 am
- Location: New Hampshire
Re: WANTED: Victrola door knob
Have this one available from a XVI. Yours looks like a bronze color finish. This one could be stripped to brass and then darkened chemically.
I have seen Bronze finish ones on the record weights on the early versions of the 2nd Victor changer and the front doors of a VV 8-7.
I would like to find a pair of front pulls for a VV 8-7 myself.
I have seen Bronze finish ones on the record weights on the early versions of the 2nd Victor changer and the front doors of a VV 8-7.
I would like to find a pair of front pulls for a VV 8-7 myself.
-
- Victor Jr
- Posts: 6
- Joined: Sun Feb 17, 2019 8:18 am
- Location: Charlotte, NC
Re: WANTED: Victrola door knob
It is on an early VV-X!V "Queen Anne."
They are more of a dark color though likely due to original finish gone.
Some more photos are attached - the door photo is the same knob, looks a bit more gold in this picture but isn't.
Thanks
MHM
- mattrx
- Victor IV
- Posts: 1140
- Joined: Wed Oct 12, 2011 9:55 am
- Location: Bartlett, TN
Re: WANTED: Victrola door knob
The knobs used on the Queene Anne XIV are the same ones used on some L-Doors. I've owned and sold 2 of the XIV's and miss them both. Nice hardware, but not the cheapest or easiest to find.
Good Luck,
Matt
Good Luck,
Matt
-
- Victor I
- Posts: 129
- Joined: Fri Oct 19, 2018 1:09 pm
- Location: Buffalo, NY
Re: WANTED: Victrola door knob
The hardware on the early VV-XIV Queen Anne machines was gold plated.