I have a warped spindle on a VV-IX motor, which I believe is the root cause to the undisclosed source of some noise while the motor runs. I have tried one spindle replacement, but it turned out to be just a wee tad too large in diameter and the threads were also a bit longer than my own. Apparently, it was a pretty exacting fit for each model motor... not much tolerance forgiveness.
Here is a photo of what I have and am looking to replace. If anyone has an unwarped one that they are looking to sell, please contact me.
Thank you!
WTB: VV-IX Worm/Endless Screw/Spindle..pick your terminology
- Tinkerbell
- Victor III
- Posts: 778
- Joined: Tue Jul 13, 2010 7:01 pm
- Location: Somewhere over Never, Neverland