FOR SALE: Columbia Frt Mt Aluminum Arms Original $295

[outune]

Here is a set of arms for Front mount Columbia- I believe this may be for an "AH", but please check measurements to be sure.

Very good condition-- no cracks. Original arms are tough to find. Several pictures attached.

The tonearm measures around 14 ¾" total length- The Support Arm measured for the distance from the case looks to be 10 ½"

Feel free to ask questions-- First to post "SOLD" is the buyer. $295 plus carefully packed shipping.
Thanks-
Brad Abell

DSCN8608.JPG (133.99 KiB) Viewed 296 times

DSCN8609.JPG (135.1 KiB) Viewed 296 times

DSCN8611.JPG (133.55 KiB) Viewed 296 times

DSCN8612.JPG (135.39 KiB) Viewed 296 times

DSCN8613.JPG (134.75 KiB) Viewed 296 times

DSCN8615.JPG (135.7 KiB) Viewed 296 times

DSCN8616.JPG (135.95 KiB) Viewed 296 times

DSCN8617.JPG (133.77 KiB) Viewed 296 times

[Kevin Clark]

Could use a set of arms for a first version AH. Travel arm looks like it should have the correct length. 14.25 from the center of the reproducer to the center of the pivot pin is what is needed. Does yours measure at this distance? The support arm is too long for this AH, need one that is 9.00 inches from the mounting surface to the pivot pin hole.

[outune]

Hi Kevin- From the center of the reproducer hole to the center of the pivot pin is 13 ½". (See pics)
I am certainly willing to sell the arms separately if either of them can work for you.
Thanks-
Brad Abell

DSCN8666.JPG (136.43 KiB) Viewed 185 times

DSCN8667.JPG (133.98 KiB) Viewed 185 times

[Kevin Clark]

An AH arm but for a later version perhaps? Comes up short for the early Victor concert style Columbia reproducer but correct for the later larger style reproducer. What would you need for just the arm?

[outune]

Thanks Kevin..I'll send a PM
Brad