Template for cygnet bracket on a Triumph Model A

[colmike1]

Not getting any response in the Tips section, so I will try here.
I am wanting to add a cygnet horn to my Edison Triumph model a. It is already been converted to two and four minute. I was wondering if anyone would happen to have a template to help me position the bracket on the back of the machine? Thanks in advance.
Mike Wohl

[dzavracky]

I could send you the measurements I used to add my cygnet to a model B triumph. But those probably wouldn’t be the same right?

David

[colmike1]

Thank you, David. No, mine hase the early style case with the banner decal, so I don't think it will be the same.
Mike

[Pete Stratford]

I don’t have a template but can offer some pictures

[Pete Stratford]

If you tap on the pictures they will rotate to correct positions and enlarge.
Pete

[Jerry B.]

A Triumph Cygnet bracket is larger than ones used on Firesides, Standards, and Homes. Mike, are you mounting a Triumph bracket on your Triumph? (I only ask because the smaller bracket is plenty strong and would do the job just fine but the mounting position would be different.)

Jerry B.

[colmike1]

Pete, thank you, those pictures really help. Jerry, yes I am using a Triumph bracket. Thank you for the photos you texted last night. That should do the trick.
Mike Wohl