Please excuse my cross post with the ‘tips and tricks’ forum but I am hoping to seek some measurements in ernest and I have a tinsmith waiting in the wings - i would be deeply grateful if someone could give me a measurement and maybe a closeup pic or two of the narrow end.
Here is my original query
Greetings,
I just wonder if anyone can kindly supply me with measurements for a 1904 Columbia AH horn?
I am presently having the tin section to my existing horn remade by a tinsmith as the original has rusted away on one side. The brass bell is fine but I would really value any measurements of the tin section from the point where it interfaces the bell to the narrow end termination.
Also, the diameter of the narrow opening would be good to know and maybe a close-up picture of this end this may help with the remanufacture of the horn. I think there is a step but am not certain?
Thankyou for any consideration.
Kind regards,
Stephen
Request : 1904 Graphophone AH horn measurement
-
- Victor Jr
- Posts: 12
- Joined: Thu May 06, 2021 7:42 am
- fmblizz
- Victor IV
- Posts: 1176
- Joined: Tue Jan 12, 2010 4:59 pm
- Location: South Jersey
Re: Request : 1904 Graphophone AH horn measurement
My original AH horn has a total length from the small end to the base of the brass bell of 15 inches.
The length of the reduced area that fits inside the elbow is a hair over ¾ inch.
The diameter of the reduced area that fits inside the elbow is just shy of 1 ⅛ inch.
See attached pic's
Hope this helps.
Blizz
The length of the reduced area that fits inside the elbow is a hair over ¾ inch.
The diameter of the reduced area that fits inside the elbow is just shy of 1 ⅛ inch.
See attached pic's
Hope this helps.
Blizz
-
- Victor Jr
- Posts: 12
- Joined: Thu May 06, 2021 7:42 am
Re: Request : 1904 Graphophone AH horn measurement
Thank you so so much - I really appreciate your trouble this is exactly what I need.
Kind regards,
Stephen
Kind regards,
Stephen
- fmblizz
- Victor IV
- Posts: 1176
- Joined: Tue Jan 12, 2010 4:59 pm
- Location: South Jersey
Re: Request : 1904 Graphophone AH horn measurement
Sounds like a tricky project Stephen.. hope you post some pictures of your progress.
Best of luck
Blizz
Best of luck
Blizz
-
- Victor Jr
- Posts: 12
- Joined: Thu May 06, 2021 7:42 am
Re: Request : 1904 Graphophone AH horn measurement
Thanks Blizz - will do. I’m keeping my fingers crossed.
Thanks again for your help with the pics - much appreciated
Kind regards,
SL
Thanks again for your help with the pics - much appreciated
Kind regards,
SL