Hi Sheraz, I've only had to replace 2 of these ball bearings and they were both 3/16 inches. They fit the hole in the casting perfectly ! Why they were missing to begin with remains a mystery as they are hard to remove even if you wanted to. Both were used in the motor that is used in the Victor VV-VI (6) machineSherazhyder wrote: ↑Mon Mar 20, 2023 12:09 am Hi Pallophotophone ! Do you mean 3/16 mm ? Because 3/16 inches is too big a size for that tiny hole. Thanks
Turn table shaft bearing
-
- Victor II
- Posts: 310
- Joined: Tue Aug 14, 2018 7:35 pm
- Location: Syracuse N.Y.
Re: Turn table shaft bearing
-
- Victor I
- Posts: 128
- Joined: Sat Oct 29, 2022 2:44 pm
- Personal Text: Another Gramophone Enthusiast
- Location: Islamabad, Pakistan
Re: Turn table shaft bearing
Hi Pallophotophone ! Thanks for your advice