Can onyone sell me a needle pot for an HMV 157 upright cabinet machine? They are fitted to many of the cabinet and table models. It's for used needles, straight sided with a slightly concave removeable top, nickel plated.
Barry
Used needle pot for HMV 157
-
- Victor IV
- Posts: 1315
- Joined: Sun May 27, 2012 2:38 pm
- Location: United Kingdom
- Orchorsol
- Victor IV
- Posts: 1625
- Joined: Wed Feb 22, 2012 9:03 am
- Location: Dover, UK
- Contact:
Re: Used needle pot for HMV 157
I have one here you'd be welcome to Barry, but it's taller than some HMV ones (about 26mm) - you're welcome to it if it suits!
Andy
Andy
BCN thorn needles made to the original 1920s specifications: http://www.burmesecolourneedles.com
Youtube channel: https://www.youtube.com/channel/UCe4DNb ... TPE-zTAJGg?
Youtube channel: https://www.youtube.com/channel/UCe4DNb ... TPE-zTAJGg?
-
- Victor IV
- Posts: 1315
- Joined: Sun May 27, 2012 2:38 pm
- Location: United Kingdom
Re: Used needle pot for HMV 157
Very kind of you, Andy, but it's too tall. The hole in the motor board is 10mm deep, so with the lid, I reckon the one I need would be around 12-15mm deep in total. Thanks, though.Orchorsol wrote:I have one here you'd be welcome to Barry, but it's taller than some HMV ones (about 26mm) - you're welcome to it if it suits! Andy
Barry
-
- Victor VI
- Posts: 3001
- Joined: Mon May 13, 2013 2:04 pm
- Contact:
-
- Victor III
- Posts: 564
- Joined: Fri Jan 06, 2012 5:22 am
Re: Used needle pot for HMV 157
Hi Barry,
I've got one you can have. Send me a private message with your address and I'll post it.
Andrew
I've got one you can have. Send me a private message with your address and I'll post it.
Andrew
-
- Victor IV
- Posts: 1315
- Joined: Sun May 27, 2012 2:38 pm
- Location: United Kingdom
Re: Used needle pot for HMV 157
Thanks Andrew, PM sent with details.Gramtastic wrote:Hi Barry,
I've got one you can have. Send me a private message with your address and I'll post it.
Andrew
Barry