Re: Wanted. Back screw at the handle of HMV winding crank
Posted: Sat Nov 12, 2022 7:53 pm
I have one, the outside of the nut is .312, which is 5/16.
The shaft where the handle slides onto measures up at .190 to .192 _ probably 3/16, that will give you an idea if yours is the same size.
I'm sure it is, why would Victor make them different sizes ?
PM with your address, I would want 10.00 Canadian dollars for it, and what ever shipping it would cost.
It's small enough to fit in a reinforced envelope, so it will go as such _ not a small package; that can get expensive.
I bought a crank for a Gramophone that I plane to build, and then a different motor came along, so I no longer need that crank.
The slot is pristine as I was very carful to find the exact flat blade to fit the slot, I usually end up grinding a screw driver to fit, but I didn't have to in this case.
The shaft where the handle slides onto measures up at .190 to .192 _ probably 3/16, that will give you an idea if yours is the same size.
I'm sure it is, why would Victor make them different sizes ?
PM with your address, I would want 10.00 Canadian dollars for it, and what ever shipping it would cost.
It's small enough to fit in a reinforced envelope, so it will go as such _ not a small package; that can get expensive.
I bought a crank for a Gramophone that I plane to build, and then a different motor came along, so I no longer need that crank.
The slot is pristine as I was very carful to find the exact flat blade to fit the slot, I usually end up grinding a screw driver to fit, but I didn't have to in this case.