Problem with second barrel

Henrik_M · Post by **Henrik_M** » Wed Oct 22, 2014 12:57 pm

Hi, the problem is that I some time ago over-winded my gramophone. I have bought new springs and is in the middle of changing them, but I have a small problem. I have taken out the two barrels from the motor, but I can not reach the second barrel because it is blocked by the first one. This makes it of course impossible for me to install both new springs. Does anyone know how I can open up the second barrel so I can install the second spring? See attached photos.

//Henrik

Post by **alang** » Wed Oct 22, 2014 2:26 pm

This thread might be helpful http://forum.talkingmachine.info/viewto ... 93&p=19515

Good luck!
Andreas

Bob · Post by **Bob** » Wed Oct 22, 2014 2:36 pm

Pull the winding gear off the shaft. Remove the pin from the shaft. The barrels should separate.
Bob

Henrik_M · Post by **Henrik_M** » Sat Oct 25, 2014 5:23 pm

Hi, found a picture on the other post, I just have one small question. Is it the small pin or the large pin that I am supposed to remove?

//Henrik

Curt A · Post by **Curt A** » Sat Oct 25, 2014 7:45 pm

Remove the small pin first, then you can remove the shaft ("large pin") and spring barrel...

Problem with second barrel

Problem with second barrel

Re: Problem with second barrel

Re: Problem with second barrel

Re: Problem with second barrel

Re: Problem with second barrel