Repairing Diaphragms-Gasket on both sides?

Hcompton79 · Post by **Hcompton79** » Mon Dec 15, 2014 6:04 pm

When putting a new diaphragm into a reproducer do gaskets go on both sides or only facing out?
Sorry I'm new to this.

Post by **Phono48** » Mon Dec 15, 2014 6:30 pm

No apologies needed!

Both sides.

Barry

Jerry B. · Post by **Jerry B.** » Mon Dec 15, 2014 7:59 pm

Both sides if at all possible. Some reproducers are made of pot metal and you run the risk of breakage from disassembly. Beware if you see lots of little cracks which an indication of something made out of pot metal. Jerry

Hcompton79 · Post by **Hcompton79** » Mon Dec 15, 2014 8:06 pm

I do believe it is made of pot metal but I see no cracks in it.

Post by **Phono48** » Tue Dec 16, 2014 6:37 am

Which soundbox is it?

Barry

Hcompton79 · Post by **Hcompton79** » Tue Dec 16, 2014 7:31 am

To be honest I still don't know what machine it is. all I could find was "E General Industries Co Ohio Junior" printed on the motor.

Repairing Diaphragms-Gasket on both sides?

Repairing Diaphragms-Gasket on both sides?

Re: Repairing Diaphragms-Gasket on both sides?

Re: Repairing Diaphragms-Gasket on both sides?

Re: Repairing Diaphragms-Gasket on both sides?

Re: Repairing Diaphragms-Gasket on both sides?

Re: Repairing Diaphragms-Gasket on both sides?