Need help with ball bearing!

Lagge0101 · **Joined:** Tue Jun 19, 2018 2:01 pm **Posts:** 13

I recently lost the ball bearing that supports the turntable spindle on my HMV 101 motor model 410. I have been looking everywhere for it, but cant seem to find it

I came to the conclusion that its better if I buy a new ball bearing of the internet. Does anyone have the diamater of the ball bearing? From what i’ve heard it is a rather small ball bearing maybe not more than 1mm. I want to have the original size when putting the motor back together.

Thanks in advance

soundgen · **Joined:** Mon May 13, 2013 2:04 pm **Posts:** 1913

Are you in the UK ? if so I'll post you one FOC you can PM me your address

Lagge0101 · **Joined:** Tue Jun 19, 2018 2:01 pm **Posts:** 13

soundgen wrote:

Are you in the UK ? if so I'll post you one FOC you can PM me your address

Check pm :p

Victrola-Monkey · **Posted:** Wed Jun 27, 2018 9:23 pm

So what size was the ball bearing? Is it 3/16" like in the Electrola motors?

Stephen_Heatherly · **Joined:** Tue Sep 19, 2017 10:30 am **Posts:** 157

When I cleaned and repaired the motor in my victor VV-VI I replaced the spindle ball because it had a large flat spot worn on it. I still have several ball bearings leftover. Measure the diameter of the spindle hole and if I have the size you need I will be glad to mail you a few of them.

Stephen

The Talking Machine Forum — For All Antique Phonographs & Recordings

Need help with ball bearing!

Who is online