The Talking Machine Forum — For All Antique Phonographs & Recordings
https://forum.talkingmachine.info/

Question on spray finishes...
https://forum.talkingmachine.info/viewtopic.php?f=7&t=41603
Page 1 of 1

Author:  Jerry B. [ Wed Aug 14, 2019 2:10 pm ]
Post subject:  Question on spray finishes...

I recently acquired an oak machine that has been refinished. It looks like a nice job but the finish is too light. I asked the previous owner about the finish and it is a lacquer. Is there an overspray that is tinted or am I looking at a refinish? Thanks for any tips. Jerry Blais

Author:  gramophone-georg [ Wed Aug 14, 2019 2:37 pm ]
Post subject:  Re: Question on spray finishes...

Jerry- Try mixing some stain into your Deft and spray some samples to see how it lays down. I have done this before and it seems to work quite well but I can't recall exactly if it was Deft I used, or if I tinted varnish as a base coat and then sprayed Deft over it.

Author:  Jerry B. [ Sat Aug 17, 2019 12:52 am ]
Post subject:  Re: Question on spray finishes...

Is there a product already in a spray can? Thanks, Jerry

Author:  gramophone-georg [ Sat Aug 17, 2019 1:07 am ]
Post subject:  Re: Question on spray finishes...

Jerry B. wrote:
Is there a product already in a spray can? Thanks, Jerry


Not that I'm aware of... sorry.

EDIT- I did some digging and found this:
https://woodrepairproducts.com/product/ ... gKLBfD_BwE

Author:  Jerry B. [ Sat Aug 17, 2019 9:51 am ]
Post subject:  Re: Question on spray finishes...

Thanks George, I appreciate your efforts. Jerry

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/