Victor round speed control disassembly

Share your phonograph repair & restoration techniques here
Post Reply
BillH_NJ
Victor II
Posts: 280
Joined: Sat Aug 11, 2018 12:14 pm
Location: Plainfield, NJ

Victor round speed control disassembly

Post by BillH_NJ »

How can one remove the round speed control from the motor board of a Victor VV-XVI? I want to use it on another motor.

Jerry B.
Victor Monarch Special
Posts: 7609
Joined: Tue Feb 10, 2009 11:25 am
Personal Text: Stop for a visit when in Oregon.
Location: Albany, Oregon

Re: Victor round speed control disassembly

Post by Jerry B. »

1- Remove the long skinny threaded screw.

2- The tapered part should slide down and off. Keep track of the spring that pushes down on this part.

3- With those parts set aside you will see a threaded collar that hold the rest of the speed control assembly tight to the motor board.

4- Note the two holes in the collar. There was probably a tool to loosen that part but I use a smaller flat bladed screw driver. Hold the screw driver at an angle with the flat blade against one of the holes. Gently tap and the collar should start to turn.

Jerry Blais

BillH_NJ
Victor II
Posts: 280
Joined: Sat Aug 11, 2018 12:14 pm
Location: Plainfield, NJ

Re: Victor round speed control disassembly

Post by BillH_NJ »

Thanks!

Post Reply