Governor repair on a Victor electric Universal motor
- Bruce_Van_Note
- Victor I
- Posts: 169
- Joined: Fri Nov 04, 2011 1:08 pm
- Location: Hesperia, CA
Governor repair on a Victor electric Universal motor
Can anyone supply information on the proper way to repair the governor assembly on a Victor Victrola electric Universal motor Model 82-C? I think I'm on the right track but I don't know if I'm missing something.
"No matter where you go, there you are"
-
- Victor IV
- Posts: 1429
- Joined: Wed May 20, 2009 8:20 pm
- Location: Mid - Michigan
Re: Governor repair on a Victor electric Universal motor
What problem are you having with it? I recently overhauled one of those and I may be able to help.
Jim
Jim
- Bruce_Van_Note
- Victor I
- Posts: 169
- Joined: Fri Nov 04, 2011 1:08 pm
- Location: Hesperia, CA
Re: Governor repair on a Victor electric Universal motor
Hi Jim! I’m not having any problems as such, but I have this feeling that what I’m doing is not the easiest way to work. I’m replacing the friction leather to control the motor’s speed. That’s not a problem. The job would be easier if I could remove the complete governor shaft assembly which holds the weights and springs, but I don’t know how to remove it. I’ve found that putting on new governor springs is difficult when one’s fingers and thumbs ate as big as mine. I hope you can help me out. Thanks, Jim.
"No matter where you go, there you are"
-
- Victor Monarch Special
- Posts: 5347
- Joined: Mon Aug 24, 2009 3:08 pm
- Location: Southeast MI
Re: Governor repair on a Victor electric Universal motor
There's a couple different versions of the Universal motor. Got a photo?