Wanted: BWT gear

[Phono-Phan]

I am working on a machine that has a bad winding gear. It is labeled BWT inside. The brass gear is shot in the picture. Does anyone have one available?
Thanks, Ken

[outune]

Hi Ken--- Hope all is well with you!
Is this what you need?? Gear is 2 ¼" in diameter. Shoot me a PM if it will work.

Brad Abell

[Phono-Phan]

PM sent

[outune]

Hi Ken- I haven't received a PM yet-- I PM'd you with my direct contact info, but it's not showing in my outbox or as a sent message. Something may be wrong with the PM feature-- We'll figure it out-- Gear isn't going anywhere until I know if you can use it.

Thanks!
Brad Abell

[Phono-Phan]

Brad,
Thanks for the gear and springs. They should work great. I hope I returned the favor enough with the repair of the spring lever needle bar on your Victor Exhibition reproducer. It was a challenge but quite rewarding. I will post the repair process in the Tips section.
Ken Brekke