Wanted: 10" Victor turntable.

[tom]

Looking for a 10" Victor cast iron turntable for Victor II, III or IV. Also looking for an original crank and "wishbone" holder and thumbscrew for back bracket. Thanks for any help you can give me.

[VanEpsFan1914]

I have a Victor III crank that needs to be straightened a little bit, and brazed on the end. Let me know if you want it. Other than some scratches, being bent a few degrees, and a cracked end it is in very good shape. It was boxed up for almost 100 years after the Victor III broke down (first bend, little crack) and then the Victor broke again (bigger crack, bent for good, lost escutcheon) and now I have a nice JAS crank on there and a Sitko escutcheon.

So I don't need the old one. Let me know.

[tom]

Thanks for the possibility. I have a repo crank and would like a good original crank if possible. I think i will hold out for an all original in good condition. I appreciate the offer.

Tom

[Benjamin Foss]

Hello,
I have all of the parts that you're seeking available. I'll send you a PM with photos and prices.
- Benjamin

[Jimmyny]

Hello do you still have the turntable, I too am looking for the Victor II 10” cast iron turntable. It also fits the Victor III and IV.

Thank you

[Jimmyny]

Hello,
I have all of the parts that you're seeking available. I'll send you a PM with photos and prices.
- Benjamin

Hi Benjamin is the part still available because I am interested

[JerryVan]

DELETED

[Jerry B.]

A cast turntable for a Victor M or MS will not fit a Victor II, III, or IV spindle.

Jerry B.

[JerryVan]

A cast turntable for a Victor M or MS will not fit a Victor II, III, or IV spindle.

Jerry B.

Thanks for the reminder Jerry!

[phonojim]

Pretty sure I have a cast iron turntable and a complete back bracket for a humpback Vic II. I, I will try to find it tonight and let you know.